ServicesResidential Plumbing
Residential Plumbing in Nashville
From a dripping faucet to a tank water heater that won't stay lit, we fix the parts of your home's plumbing you use every day, including toilets, shutoff valves and pressure regulators. We close off water and power at the source first, then check pressure and temperature before you use anything again.
Plumbing repairs that leave your home safer than we found it
Most household plumbing trouble comes from a handful of parts that wear out on a schedule. Rubber washers and cartridges harden, gate valves seize after years of sitting open, pressure regulators drift, and water heater relief valves get forgotten until they matter. We replace those parts with the right match and explain why each one failed.
Safety first is how we run every visit. Before we open a line, we confirm the water is off and stays off. Before we touch a water heater, we shut off the gas or the breaker. And before we pack up, we test what we touched and the parts around it that affect your family's safety, like scald temperature and static water pressure.
If a repair is the honest answer, you get a repair. If a fixture or heater is past saving, we show you why and give you the replacement option in writing.
What our residential plumbing work covers
Faucets and toilets
We replace worn faucet cartridges, toilet fill valves, flappers and wax rings, or install a new fixture when the old one is cracked or obsolete. A toilet that rocks on the floor gets a new wax ring and closet bolts, and we check the flange underneath.
Shutoff valves and supply lines
Old multi-turn stops often seize or won't close fully, which leaves you with no way to stop water in a hurry. We swap them for quarter-turn ball valves and replace plastic supply lines with braided stainless, which holds up far better under pressure.
Pressure reducing valves
We put a gauge on a hose bib and read your static pressure. Plumbing code caps household pressure at 80 psi, and anything above that strains fixtures, appliance hoses and water heater tanks. A failed regulator gets replaced and set to a safe range.
Tank water heater service and replacement
We test the temperature and pressure relief valve, check that its discharge pipe runs where it should, inspect the venting on gas units and add a thermal expansion tank where the system needs one. For on-demand units, see our Tankless Water Heater Installation page.
Outdoor hose bibs
We install frost-free sillcocks with built-in vacuum breakers. The valve seat sits inside the heated wall, so the line can drain before a hard freeze, and the breaker keeps garden water from siphoning back into your drinking supply.
Signs your home needs a plumber's attention
A shutoff that won't turn
If the valve under a sink or behind a toilet is frozen in place, you have no quick way to stop water during a failure. That is worth fixing before you need it.
Banging pipes or a toilet that refills on its own
Water hammer and phantom refills often point to high pressure or a worn fill valve. Both waste water, and high pressure shortens the life of everything connected to the line.
Water from the relief valve
A temperature and pressure relief valve that drips or discharges is telling you the tank is overheating or over-pressurized. Do not cap it. Turn the heater off and give us a call.
Hot water that scalds
Tap water above 120°F can burn a child or older adult in seconds. A misadjusted thermostat or a missing mixing valve is usually the cause, and both are simple to correct.
Rusty hot water or a rumbling tank
Brown hot water and popping sounds mean sediment buildup or a spent anode rod. We'll tell you whether flushing helps or whether the tank is near the end.
A spigot that froze last winter
Nashville gets only a few hard freezes a year, but one is enough to crack a standard hose bib. A frost-free replacement prevents a repeat.
How a residential plumbing visit runs
- 1
Your call and a free estimate
Tell us what you're seeing and hearing. We schedule a visit, look at the problem in person and give you a written estimate before any work begins.
- 2
Isolate and protect
We locate and test the shutoffs, kill power or gas to any water heater we're working on, and lay down drop cloths and towels under the work area.
- 3
Repair with matched parts
We install parts sized and rated for your fixture or heater. You can see the old part and we'll point out exactly where it failed.
- 4
Test before we leave
We restore water slowly to purge air, check every joint we made, read static pressure and measure hot water temperature at a nearby tap. Water heaters get a relief valve check and a full heat cycle.
- 5
Cleanup and walkthrough
We haul away old parts, wipe down the area and show you where your shutoffs are and how they work.
What affects the cost of residential plumbing work
Your price comes from the parts, the access and what we find around the problem. You get a written estimate before we start, and it doesn't change unless you approve a change. Pay with cash or any major credit card, and ask us about financing options for larger jobs.
- Parts and fixtures
- A cartridge or fill valve costs far less than a new faucet or toilet. If you're buying the fixture yourself, we'll check that it fits your rough-in before install day.
- Access
- A valve in an open basement is quick. One behind a finished wall, inside a tight vanity or in a low crawlspace takes more time.
- Condition of the surrounding pipe
- Older galvanized nipples and corroded threads can snap when a fitting is loosened. If the pipe next to the repair is too far gone to hold, we tell you before going further.
- Code updates and permits
- Replacing a water heater can mean adding an expansion tank, correcting a discharge line or pulling a permit and inspection. We list each item separately so you can see why it's there.
- Timing
- Scheduled work costs less than an after-hours emergency visit. If it can safely wait, we'll say so.
Residential plumbing questions
Something not covered here? (615) 560-9798
Can I reach you if something fails late at night?
Any hour, any day. Our 24/7 emergency plumbing service covers the problems that can't wait until morning. If water is running where it shouldn't, close the main shutoff first and then call. If your water heater's relief valve is discharging, also turn off its gas supply or breaker.
Why do you check my water pressure on a faucet call?
High static pressure is one of the most common reasons faucet cartridges, toilet fill valves and washing machine hoses fail early. A quick gauge reading tells us whether the repair will last or whether a pressure regulator is the real fix. It takes a few minutes and we share the number with you.
Does a water heater replacement need a permit?
In most cases, yes. A replacement water heater generally calls for a plumbing permit and inspection, mainly to verify venting, gas connections and the relief valve. We pull the permit when one is required and include it on your estimate.
Can you install a water filter while you're here?
Under-sink and fixture work can be done on the same visit. For a filter on the main line that treats all the water in your home, see our Whole Home Water Filtration page, and we can quote both together.
How do I pay for a larger repair?
Cash and every major credit card work for any job. For bigger projects like a water heater replacement, financing options are available. Mention it when you call for your estimate and we'll walk you through it.
Get a safe fix and a straight answer
Tell us what's dripping, banging or running cold, and we'll come look and give you a written price before any work starts. If it can't wait, we answer around the clock.